Closed. This question is off-topic. It is not currently accepting answers. Want to improve this question? Update the question so it’s on-topic for Server Fault. Closed 6 years ago. Improve this question I am looking to beef up security on an office network. Aside from the obvious: physical security, limiting user privileges using Active Directory, … Read more
While browsing through the lenovo PSREF (tabook) for X220 model number 4287 (page 69) I noticed models that support iAMT and vPro and models that do not. Can anyone shed some light on this. Some models have the same processor and I assume same motherboard but one supports vPro/iAMT and the other not. Example: 4287-3KU … Read more
This is very strange. I can not boot up from an USB device until I reboot and close the connection immediately. Then everything works well. I can not provide more information than this, because I don’t know more. I don’t even know, where I could get logs… Answer Since I installed syslinux in stupid mode, … Read more
I’m trying to get AMT working on a brand new DQ77KB motherboard. I’ve followed this setup guide but I can’t login to the web interface (http://[IP]:16992) or though the KVMControlApplication.exe. Both approaches gives me a 401 Unauthorized. I’m using admin as the username, I’ve tried a lot of different passwords containing different special letters, I’ve … Read more
We have a number of HP EliteDesk workstations of varying models (8300, 800 G1) in our organization, some of which started exhibiting strange behavior over the past few months. Checking the Intel AMT event logs we see every 2-3 minutes the following error message being logged: Operating system lockup or power interrupt. The machines in … Read more
Model:30AT0054PB (ThinkStation P310) SN: S4AM6910 BIOS rev: FWKT80A ME Firmware rev: 11.0.27.3000 Has anybody have any success with running VNC via KVM/AMT connection to P310 in headless mode (without monitor)? BIOS and Intel ME Firmware updated. In my situation as soon as I disconnect VGA cable, the vnc client disconnects with error: Error 0x80862000. Unsupported … Read more
I have a server that’s recently been crashing occasionally in odd ways, so I decided to configure up Intel AMT on it in the hope of being able to reset it remotely when this happens. For better or for worse, in the current set up, this server has a dynamic IP address, but things are … Read more
I have to host multiple servers in a collocation center which is distant over 250 km. I need to have as good remote control over the servers as possible. In other words, I need to be able to access BIOS of the servers, be able to turn the servers ON or OFF, or to remotely … Read more
I have several intel NUC (NUC5i5MYBE) hosts with AMT support and an up-to-date firmware (2017-05-06). I am able to send power-up and (hard) power-off and get the correct power info using amtc and Python AMT Tools According to the AMT 9.x notes there should be a way to send graceful shutdown (12) and graceful reboot … Read more
I have never worked with AMT, I would like to make sure the following scenario would be possible before I start to invest in a few Intel AMT machines. Let’s assume the server has two NICs and each NIC has a different internet connection. Would it be possible to use one NIC for Intel AMT … Read more
